04-23-2009 06:43 AM
We switched internet service providers so i had to change the peer ip address and since than i cannot get the tunnel to connect any ideas?
04-23-2009 08:08 AM
Check your config, check if the providr allows IPSEC traffic - also consider configuring NAT-T.
HTH>
04-23-2009 01:01 PM
Thank you for your response. As i pointed out in the original post the configuration is about a year old and was working fine. As far ipsec traffic i will check and let you know.
04-27-2009 04:47 AM
I spoke to the isp and they claim they are not blocking ipsec traffic
04-27-2009 04:48 AM
Well just in case they - enable NAT-T on the tunnels
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: