Add static ip route in CUCM 6.X

Answered Question
Apr 24th, 2009


does anyone know the command to add a static ip route in CUCM it even supported?



I have this problem too.
0 votes
Correct Answer by htluo about 7 years 5 months ago

It's not supported. On CUCM 6.x, you can only specify default gateway. Any routing function was performed by gateway.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
balasundaram.k_2 Tue, 10/27/2009 - 04:09

Even I was looking for an answer for the same question. Thank you very much, Michael.



anjali.garg Thu, 12/15/2011 - 06:02


Could someone please confirm if we can add static route on CUCM 7.x series and if yes, what is the command ?


George Thomas Thu, 12/15/2011 - 06:47

Nope not possible in 7 as well.

Sent from Cisco Technical Support iPhone App

anjali.garg Thu, 12/15/2011 - 07:15

Hi George,

Thanks for your reply , juts to rule out this option completely, can someone please confirm if it is at all possible with any CUCM  version , just wondering if latest version 8.x supports this?

Thanks in advance,



George Thomas Thu, 12/15/2011 - 07:37

Hi Anjali,

Unfortunately no. The OS for CallManager is pretty much locked down. There are only a couple of commands that can be run from the OS level. Here is the CLI guide for the latest version of CallManager outlining what commands are available.

I am guessing if you have a specific need to route traffic, you probably will have to use route maps on the layer 3 switch.


This Discussion