04-24-2009 06:09 AM - edited 03-15-2019 05:38 PM
Hi,
I am having a lot of problems setting up a VWIC BRI in a Cisco 1861 that is connected BRI in Malta. As I am working on this remotely I am having a lot of difficulty getting information to configure this.
The ISDN's will be under MGCP control; however when I carry out a âshow ISDN statusâ the layer 1 is showing as DEACTIVATED. If possible please could someone give me some guidance on the general setup.
Many thanks in advance
Solved! Go to Solution.
04-24-2009 10:43 AM
That is normal, then when an in or out calls happens, the BRI becomes fully activated. Remember to configure "isdn tei-negotiation preserve" under bri interface.
Also, for added stability and ease of troubleshooting, recommend you use the port in h.323 mode.
04-24-2009 10:43 AM
That is normal, then when an in or out calls happens, the BRI becomes fully activated. Remember to configure "isdn tei-negotiation preserve" under bri interface.
Also, for added stability and ease of troubleshooting, recommend you use the port in h.323 mode.
04-24-2009 10:51 AM
Many thanks for this I will try this when I get back to work on Monday.
Also do you know if you set the ISDN up as Basic Net 3?
Cheers
Richard
04-24-2009 10:54 AM
Yes, you do.
04-24-2009 01:52 PM
Many Thanks
04-25-2009 01:11 AM
You're welcome. Please remember to rate useful posts with the scrollbox below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: