WAE-512 disk failure

Answered Question
Apr 24th, 2009

A WAAS withe dual disk DISK-SATA2-250GB. One disk failed and I want to replace the drive.

The question is, once I swap the drives will the new drive get rebuilt automatically?

Thanks

I have this problem too.
0 votes
Correct Answer by dstolt about 7 years 7 months ago

Follow the following instructions on cisco.com

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v413/configuration/guide/maint.html#wp1139597

Also remember, the WAE-512 doesn't have hot swap cabability, so you should power off the device after you have performed the "disk disk-name diskxx shutdown" command before pulling the faulty drive.

Hope that helps,

Dan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
dstolt Fri, 04/24/2009 - 12:50

Follow the following instructions on cisco.com

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v413/configuration/guide/maint.html#wp1139597

Also remember, the WAE-512 doesn't have hot swap cabability, so you should power off the device after you have performed the "disk disk-name diskxx shutdown" command before pulling the faulty drive.

Hope that helps,

Dan

Actions

This Discussion