Polycom VTX (analogue) on a UC520

Unanswered Question
Apr 24th, 2009

There's probably a really easy way to do this, but I'm trying to get a Polycom VTX Analogue conference phone working on my UC520.

The UC520 has an ISDN PRI (E1) on a VIC card and the standard 4 x FXS, 4 x FXO.

I've plugged the Polycom in to one of the FXS ports and get no dial tone, just a 'slow-fast' signal (not sure if that makes sense!!).

Any help would be greatly apprecitated.

Thanks in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Paolo Bevilacqua Fri, 04/24/2009 - 10:41

Change dialtone configuring "cptone" under voice-port. You should also be able to dial.

campbell.thomps... Fri, 04/24/2009 - 10:45

I have the cptone under voice-port set as follows, but I still don't get a dialtone...

voice-port 0/0/0

cptone GB

timeouts ringing infinity

caller-id enable

!

Paolo Bevilacqua Sat, 04/25/2009 - 01:43

Are you trying SCCP controlled ports, is there a DP refering to the same port with application stcapp ?

Actions

This Discussion