04-24-2009 07:42 AM - edited 03-15-2019 05:39 PM
There's probably a really easy way to do this, but I'm trying to get a Polycom VTX Analogue conference phone working on my UC520.
The UC520 has an ISDN PRI (E1) on a VIC card and the standard 4 x FXS, 4 x FXO.
I've plugged the Polycom in to one of the FXS ports and get no dial tone, just a 'slow-fast' signal (not sure if that makes sense!!).
Any help would be greatly apprecitated.
Thanks in advance.
04-24-2009 10:41 AM
Change dialtone configuring "cptone" under voice-port. You should also be able to dial.
04-24-2009 10:45 AM
I have the cptone under voice-port set as follows, but I still don't get a dialtone...
voice-port 0/0/0
cptone GB
timeouts ringing infinity
caller-id enable
!
04-25-2009 01:43 AM
Are you trying SCCP controlled ports, is there a DP refering to the same port with application stcapp ?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: