Somebody help!!!

Unanswered Question
Apr 24th, 2009

I really am getting to the point of frustration!! Any help will be gratefully received...

I have a UC520 with an E1 going in to a VIC. I have succesfully set up and am using 8 x 524SG's on it and want to use a Polycome VTX 1000, a simple analogue conference phone on one of the FXS ports.

When I plug the polycom in, I don't get a dialtone, I just get an engaged tone, with a fast tone, then a slow tone, fast, then slow... You get the picture...

What am I doing wrong? Is there anything special that I need to do?

Any prods in the right direction would be fantastic...

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Justin Brenton Sat, 04/25/2009 - 03:47

You have to configured the FXO port to support the Polycom VTX Device.

You will also need supported Dial plan to support the device.

Regards,

Justin

campbell.thomps... Sat, 04/25/2009 - 05:08

So it would go in to the FXO and not the FXS? I thought the FXS was for analogue devices. How would the dial plan vary?

Actions

This Discussion