cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4282
Views
0
Helpful
6
Replies

intervlan routing

dflores83
Level 1
Level 1

Hi
I have a new UC520 and have a problem with inter-Vlan communication, I do 3 vlan but,   I can´t ping the vlan4 fron vlan 1

And from the laptop I can´t connect to Wvlan (vlan 4)


I attachment the config
thanks

6 Replies 6

dlkoch
Level 1
Level 1

You have the wrong default-router in you DHCP scopes


ip dhcp pool data
   network 192.168.10.0 255.255.255.0
   default-router 192.168.1.1   SHOULD BE 192.168.10.1
   dns-server 192.168.1.1 192.168.1.1
!
ip dhcp pool video
   network 192.168.12.0 255.255.255.0
   default-router 192.168.1.1   SHOULD BE 192.168.12.1
   dns-server 192.168.1.1 192.168.1.1

thnaks,

but

I was thinking, tah mabe should be a NAT problem??

some suggestion

I am not sure what you mean by a NAT problem.  The advice given is correct.  Change the default gateway on the pool and this should work.

And you dont specify a nat pool of address either.  You show pool 1 but there is no pool of address.

hi

I change the default route, thanks.

but

I do traceroute into two address

destination 192.168.12.3  source 192.168.10.12

the said that gateway don´t know the subnet 192.168.10.1

Do you have other devices in the network?  I am not sure how when you traceroute from a 192.168.10.0/24 address you get that the gateway doesn't know about 192.168.10.1.

Can you show a topology?  Also, can you show the switchport configuration?  How are the devices connecting to the UC500?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: