How to configure Router to Router serial connection?

Answered Question
Apr 25th, 2009
User Badges:

I have two 2610 routers and they each have a WIC-1T card. I connect them through a CAB-6060 Back-to-Back DTE-DCE cable. "Show inter s0/0" shows the connection is up/up. However can't ping each end... I also tried to put "encapsulation ppp" but still no go... How should I configure it? Thanks!

Correct Answer by davy.timmermans about 8 years 3 months ago

did you configure a clock rate at the DCE side?


for example:

clock rate 64000


to check if the side is DTE/DCE:

show controllers serial ser0/0


you'll see in the text or DTE or DCE


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
davy.timmermans Sat, 04/25/2009 - 12:21
User Badges:
  • Silver, 250 points or more

did you configure a clock rate at the DCE side?


for example:

clock rate 64000


to check if the side is DTE/DCE:

show controllers serial ser0/0


you'll see in the text or DTE or DCE


david-lima Sat, 04/25/2009 - 19:37
User Badges:
  • Bronze, 100 points or more

Hi, also check if "ip routing" command is enabled in both routers.

Best regards

David

Actions

This Discussion