Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
455
Views
0
Helpful
3
Replies

How to configure Router to Router serial connection?

Go to solution
Difan Zhao
Level 5
Level 5

‎04-25-2009 12:14 PM - edited ‎03-06-2019 05:23 AM

I have two 2610 routers and they each have a WIC-1T card. I connect them through a CAB-6060 Back-to-Back DTE-DCE cable. "Show inter s0/0" shows the connection is up/up. However can't ping each end... I also tried to put "encapsulation ppp" but still no go... How should I configure it? Thanks!

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
davy.timmermans
Level 4
Level 4

‎04-25-2009 12:21 PM

did you configure a clock rate at the DCE side?

for example:

clock rate 64000

to check if the side is DTE/DCE:

show controllers serial ser0/0

you'll see in the text or DTE or DCE

View solution in original post

0 Helpful
3 Replies 3

Go to solution
davy.timmermans
Level 4
Level 4

‎04-25-2009 12:21 PM

did you configure a clock rate at the DCE side?

for example:

clock rate 64000

to check if the side is DTE/DCE:

show controllers serial ser0/0

you'll see in the text or DTE or DCE

0 Helpful

Go to solution
david-lima
Level 4
Level 4
In response to davy.timmermans

‎04-25-2009 07:37 PM

Hi, also check if "ip routing" command is enabled in both routers.

Best regards

David

0 Helpful

Go to solution
Difan Zhao
Level 5
Level 5

‎04-26-2009 07:39 AM

Thank you guys! Worked!

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card