04-25-2009 12:14 PM - edited 03-06-2019 05:23 AM
I have two 2610 routers and they each have a WIC-1T card. I connect them through a CAB-6060 Back-to-Back DTE-DCE cable. "Show inter s0/0" shows the connection is up/up. However can't ping each end... I also tried to put "encapsulation ppp" but still no go... How should I configure it? Thanks!
Solved! Go to Solution.
04-25-2009 12:21 PM
did you configure a clock rate at the DCE side?
for example:
clock rate 64000
to check if the side is DTE/DCE:
show controllers serial ser0/0
you'll see in the text or DTE or DCE
04-25-2009 12:21 PM
did you configure a clock rate at the DCE side?
for example:
clock rate 64000
to check if the side is DTE/DCE:
show controllers serial ser0/0
you'll see in the text or DTE or DCE
04-25-2009 07:37 PM
Hi, also check if "ip routing" command is enabled in both routers.
Best regards
David
04-26-2009 07:39 AM
Thank you guys! Worked!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: