HWIC-1CE1T1 problem

vibrisnet · ‎04-27-2009

Hi all,

I try to set up a HWIC-1CE1T1 on a 2811 router, with IOS c2800nm-ipbase-mz.124-11.XW10.bin.

The controller seems to be OK, but as i connected it to the PRI :

- it stays down

- i have a message saying that "the remote received an alarm".

Did someone have the controlers parameters to set up in France ?

For now, i just have :

controller E1 0/1/0

framing NO-CRC4

pri-group timeslots 1-31

I tried to add a clock source with the same result.

If i put another router (not a Cisco), the PRI goes up without any problem.

Thanks for your help.

paolo bevilacqua · ‎04-27-2009

May be framing is CRC4. Take "show controllers E1" is both cases. There are no other parameters to set.

vibrisnet · ‎04-28-2009

I tried both CRC4 and NO-CRC4, with the same result.