04-27-2009 10:16 PM - edited 03-06-2019 05:25 AM
i am unable to configure controller e1 interface on a new cisco 1841 router.
i am trying to configure a serial interface but the option is not there too.
IOS - Version 12.4(15)T7
what could be the reason ?
yourname(config)#contro
yourname(config)#
i do not see the controller options there.
04-27-2009 10:29 PM
Hi
Did you check the IOS which is present in router supports controller command.
Can you send us show run output.
Thanks,
Satish
04-27-2009 10:39 PM
don't you first have to enable the card?
card type e1 0 0 (if it's in slot 0/0)
04-27-2009 10:39 PM
Hi
Below images supprots T1/ E1 options.
12.4(11)XW9 c1841-ipbasek9-mz.12.4-11.XW9
12.4(11)XJ4
c1841-ipbasek9-mz.12.4-11.XJ4
12.4(6)XE3
c1841-ipbasek9-mz.12.4-6.XE3
12.4(2)XA
c1841-ipbasek9-mz.12.4-2.XA
12.4(22)T
c1841-ipbasek9-mz.12.4-22.T
12.4(21a)
c1841-ipbasek9-mz.12.4-21a
12.3(11)YZ2
c1841-ipbase-mz.12.3-11.YZ2
Cheers ,
Satish
04-28-2009 01:57 AM
managed to solve the problem after i add
card type e1 0 0
then the controller option appears
controller e1 0/0/0.
didnt know that i need the card type option.
04-28-2009 02:10 AM
yes indeed, as I thought (see above)
If you insert for example a VWIC, you first need to enable the card
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: