04-28-2009 04:31 AM - edited 03-15-2019 05:42 PM
Hi,
Since I wasn't able to make the fax working good on my 2801, I m trying with another IOS but on another router (2821)
It's not the first use of this router, but I can't test now in another configuration.
Here are a part of sh ver :
Cisco IOS Software, 2800 Software (C2800NM-ADVENTERPRISEK9-M), Version 12.4(9)T, RELEASE SOFTWARE (fc1)
Cisco 2821 (revision 53.51) with 249856K/12288K bytes of memory.
2 Gigabit Ethernet interfaces
2 Channelized E1/PRI ports
1 Virtual Private Network (VPN) Module
DRAM configuration is 64 bits wide with parity enabled.
239K bytes of non-volatile configuration memory.
62720K bytes of ATA CompactFlash (Read/Write)
So I m trying to report my configuration from my 2801 to this 2821.
But I haven't the command voice-port in this 2821, is that normal ?
I'm not usual with telephony thing...
04-28-2009 04:34 AM
Yousri,
You will only see "voice ports" when you configure pri-time slots on your gateway. The voice ports are automatically created.
Post a copy of your config here
04-28-2009 04:57 AM
Ok,
I have tried, but It tells me that I haven't dsp resource for that...
Need to buy some stuff I think...
04-28-2009 05:00 AM
Can you do a show diag and post the output?
04-28-2009 05:29 AM
Yes,
You need DSPs to terminate voice calls. If you do a show diag, you should see if you have DSPs on your router or not
04-28-2009 10:18 PM
No DSPs on this router.
Just buy one PVDM2-32. Will try after the delivery. Thanks for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: