04-28-2009 06:32 AM - edited 03-11-2019 08:24 AM
Hi,
I've configured a active/passive cluster with a couple of 5520s. When making changes to the cluster, I don't worry about primary/secondary or active/standby, I simply use the ip address of the active ASA.
Is this ok/normal/best practice? Does it matter that right now I'm logging into the secondary - active ASA to make changes?
Thanks!
04-28-2009 11:58 AM
Make changes to the primary device and you'll be OK. Actually you'll get an error if you're on the back up device and you try and make a change.
ASA# config t
**** WARNING ****
Configuration Replication is NOT performed from Standby unit to Active unit.
Configurations are no longer synchronized.
ASA(config)#
Hope that helps.
04-28-2009 12:13 PM
It helps! Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide