cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
616
Views
0
Helpful
6
Replies

RME device inventory on LMS 2.6

eliaspaulos
Level 1
Level 1

I have 2 devices their config are archived on RME however RME unable to collect inventory. every inventory job has been failed. and I couldn't found any reason for the failure only I got "inventory never collected" what is the probable cause? thanks.

1 Accepted Solution

Accepted Solutions

That's the problem. There is a known loop in the ENTITY-MIB in this version of IOS. You need to upgrade to 12.3(2) or higher.

View solution in original post

6 Replies 6

Joe Clarke
Cisco Employee
Cisco Employee

You'll need to post the IC_Server.log after running an inventory collection against these devices.

Thanks,I have attached the log.

Are these routers running 12.3(1)?

appears to be...here is sh ver. output

IOS (tm) C2600 Software (C2600-ENTBASE-M), Version 12.3(1a), RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2003 by cisco Systems, Inc.

That's the problem. There is a known loop in the ENTITY-MIB in this version of IOS. You need to upgrade to 12.3(2) or higher.

ok,Thanks

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: