04-28-2009 09:06 AM - edited 03-04-2019 04:33 AM
Hi Team,
i continue to see an increment in
DS3/E3: G.832 FEBE errors
telco, tested several times, and my HW was replaced, chassis, DS3 CARD, and cable too... please see ATTACHED config, and output of DS3/E3: G.832 FEBE errors, any other thoughts.
IOS is:
12.4.6.T7
CHASSIS: 3845, AIM-1A-T3
Thanks
05-05-2009 10:20 AM
FEBE errors are "Far End Block Errors" You may want to check the physical cable or check the provider end equipment And ensure frequency match between the this end and the far end devices. This document provides troubleshooting tips for ATM over digital signal level 3 (DS-3) and E3 router interfaces.
http://www.cisco.com/en/US/tech/tk39/tk48/technologies_tech_note09186a0080111093.shtml
05-05-2009 01:55 PM
Do the errors come in burst of uniformly ?
Has telco made a 24h BER test ?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide