rate limit per user traffic with WLC

Unanswered Question
Apr 29th, 2009

Hello ,

I would like to limit the user bandwidth with WLC. I would like to sell the internet service to the houses which are provided to employees. For this reason i am traying to limit the speed for the per user.

In this address ; http://www.cisco.com/en/US/docs/wireless/controller/5.2/configuration/guide/c52ccfg.html#wpxref21838

Using the CLI to Configure QoS Profiles

To define the average data rate in Kbps for TCP traffic per user, enter this command:

config qos average-data-rate {bronze | silver | gold | platinum} rate

I see this command option. What is this for , is this option helps me ?

Regards...

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
carenas123 Thu, 05/07/2009 - 11:12

To define the average data rate in Kbps for TCP traffic per user, use the config qos average-data-rate command.

hasmurizal Mon, 05/11/2009 - 19:12

hi

those config are for QoS profile, which i think is not the bandwidth limit for the user. perhaps you might consider another appliance which can do traffic-shapping or you can surf on the net for router traffic shapping (try limitting via ip address bw allocation)

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode