PRI flapping

Unanswered Question
Apr 29th, 2009
User Badges:
  • Blue, 1500 points or more

I am getting the following in my logs any ideas as to what could be causing this?


Apr 29 11:57:02.238 EDT: %CONTROLLER-5-UPDOWN: Controller T1 3/0, changed state to down (RAI detected)

Apr 29 11:57:02.242 EDT: %ISDN-6-LAYER2DOWN: Layer 2 for Interface Se3/0:23, TEI 0 changed to down

Apr 29 11:57:04.238 EDT: %LINK-3-UPDOWN: Interface Serial3/0:23, changed state to down

Apr 29 11:57:04.238 EDT: %CONTROLLER-5-UPDOWN: Controller T1 3/0, changed state to up

Apr 29 11:57:04.342 EDT: %ISDN-6-LAYER2UP: Layer 2 for Interface Se3/0:23, TEI 0 changed to up

Apr 29 11:57:06.242 EDT: %LINK-3-UPDOWN: Interface Serial3/0:23, changed state to up


Mike

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
Giuseppe Larosa Wed, 04/29/2009 - 11:13
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Mike,

there was a problem on the T1 line with alarm RAI = Remote Alarm Indicator detected then the alarm was withdrawn and the controller and line came up again.


If this has happened many times you should call the ISDN provider and ask them to verify the line.


Hope to help

Giuseppe


burleyman Thu, 04/30/2009 - 03:58
User Badges:
  • Blue, 1500 points or more

Thanks for the reply. That is what I thought. I have not done a lot of troubleshooting with PRI's and I just wanted to make sure I was not missing something.


Mike

Actions

This Discussion