We are having a heck of a time trying to get consistent results on catos boxes whether its 4006's or 6500's running catos . You run a netconfig job and a lot of the 4006's seem to go ok but still get a fair amount of failures say 13 out of 50 saying they could not create a ssh session . SSh is configured on the boxes and you can ssh to the device without an issue , no differences in the configs between ones that work and ones that don't work, running catos 7.6.17. The 6500's have the same issue whether its a sup1 running 7.4.3 or a sup2 running 7.6.21 , these have a much higher job failure rate of probably 75-80% . SSH configured on all boxes. On the ones that fail they will also fail when trying to do netshow commands with ciscoworks . Not sure where to go with this . Think RME is 3.5 . Does ciscoworks have a ssh key cache that might need to be cleared or something of that nature ? Any help appreciated....