04-29-2009 01:44 PM - edited 02-21-2020 03:25 AM
Hi All,
I want to implement a NAC appliance for a small network of users that connect directly to non-Cisco switches.
As I understand, my only option is to deply NAC in in-band mode, in this way it does not matter which switch I use because the traffic will just pass through and get to the NAC appliance, is this correct?
Thank you!
04-30-2009 04:46 AM
yes this is correct. you will configure dot1q trunking between the nac appliance server (CAS) and the switch.
05-07-2009 12:45 PM
Correct. In in band mode (Real IP or Virtual Gateway) All traffic passes through the CAS (There is a good webcast on CCO detailing exactly how to setup both options)see link below.
Regards
Colin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: