Robert.N.Barrett_2 Wed, 04/29/2009 - 15:29

You can "prime" the access point by manually/directly configuring items like the AP's IP address and the IP address of the controller, or you can use DNS/DHCP to allow the AP to automagically discover the controller.


Here are a few links worth reading:


http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a00806c9e51.shtml


http://www.cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml


http://www.cisco.com/en/US/docs/wireless/controller/5.2/configuration/guide/c52lwap.html

(if you are not running 5.2 code on your controller, just grab the same section from the relevant 4.2/5.1 config guide)

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode