Remote ring and led signalization

Unanswered Question
chrisluven Thu, 04/30/2009 - 08:01
User Badges:

Maybe you wanna try if there is a doorbell wich is Plugable to analog telephone lines.

If it is possible just configure an ata as share line and plug the bell into the ata.

The bell now rings and you can go to the IPphone

Rob Huffman Thu, 04/30/2009 - 08:05
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Alexandrine,


The Strobe/Loud Ringer will need to be connected to an Analog ATA (as a shared line with IP Phone) or FXS Port. So if the DN in question is 5444 on the IP Phone you would setup an ATA, FXS or VG202 with the same DN (5444) so this analog connection can trip the cct. needed to activate the Strobe/Loud Ringer . I have had good luck with the Viking product line :)


http://www.smarthomeusa.com/Shop/Phone/Viking-Phone-Accessories/Item/BLK-3-EWP/specifications/


http://www.algosolutions.com/pdf/AN-0703.pdf



Hope this helps!

Rob


chrisluven Thu, 04/30/2009 - 08:16
User Badges:

Nice Description Rob, ( 5points )


I was a little bit lazy in describing the possibility of ata's.


greetings


Chris

Actions

This Discussion