Remote Access to AIR-AP1231G-A-K-9

super4visor · ‎04-30-2009

I have two FastEthernet configured in the AP; Fas0.150 & Fast0.151, each one of them dedicated to a VLAN. I gives the BVI1 an address from the Fast0.150 range and I connect the AP to the Ethernet port as trunk in the switch. I cannot connect to neither Fas0.150 nor the BVI1. My question is which address should allow me to access from the WEB?

Leo Laohoo · ‎04-30-2009

Remove the IP Address on FastEthernet0.150.

Remove the following from Fast0

bridge-group 1

no bridge-group 1 source-learning

bridge-group 1 spanning-disabled

HTTP into the BVI.