Crazy NAT and VPN

Unanswered Question

We have two VPN tunnels one is using site-2-site and the other is using easyvpn. They both terminate on the same interface, and we of course have the same-security-traffic commands entered. We have several VPN's terminating on these interfaces that can communicate fine. The issue is this, one of the tunnels is NAT'ed, so anything going to or from it has to be NAT'ed. It looks like the Firewall does the translations one direction, because we can see hits in the xlate table. however it is not working. Any ideas.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
zulqurnain Fri, 05/01/2009 - 13:27
User Badges:
  • Bronze, 100 points or more

Could you post ur fw config? It might be difficult to analyse

Actions

This Discussion