configure cmd not available for 1131ag access point

Unanswered Question
Apr 30th, 2009

I have connected to my new 1131ag access point with a serial cable and hyperterminal and am able to get a list of commands.

I enter "enable" and my password to get a list of more commands.

But at this point there is not "configure" command available as is stated in the documentation.

Also, this device is plugged into a local network and has been assigned an IP address from DHCP. When I try to connec to that address in my browser it does connect to anything.

Is there something I have missed that I need to do to be able to configure this access point via the console interface or the browser interface?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
cindy toy Thu, 05/07/2009 - 00:16

Hello,

Thanks for posting. Since this is not a small business product, I suggest posting this question in the Cisco NetPro Community http://forum.cisco.com/eforum/servlet/NetProf?page=main for input from appropriate subject matter experts. NetPro is a peer and expert forum where you can get suggestions and information from networking professionals on a variety of solutions and technologies.

Let me know if you have any questions.

Cindy Toy

Cisco Small Business

Support Community Manager


Actions

This Discussion