LWAP Rogue Detector AP - alerting

Unanswered Question
May 1st, 2009
User Badges:

Has anyone figured out a way to get an AP set in Rogue Detector mode to stop alerting radio down/assoc/disassoc. The radio is down I understand but if you leave an AP in RD mode to monitor wired traffic you are going to get a flood of alerts...


Using v4.2.176. Thanks,

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
George Stefanick Fri, 05/01/2009 - 14:40
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

You can change the sigs under

Security-> Wireless Protection Policys-> Standard Sigs -> Click on the number to change


I hope this helps

Leo Laohoo Sun, 05/03/2009 - 14:51
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

In addition to George's post, try this:


Management > SNMP > Trap Controls


Go to the Client Tab for the Association and go the the AP Tab for the Radios.


Hope this helps.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode