LWAP Rogue Detector AP - alerting

cchandler63 · ‎05-01-2009

Has anyone figured out a way to get an AP set in Rogue Detector mode to stop alerting radio down/assoc/disassoc. The radio is down I understand but if you leave an AP in RD mode to monitor wired traffic you are going to get a flood of alerts...

Using v4.2.176. Thanks,

George Stefanick · ‎05-01-2009

You can change the sigs under

Security-> Wireless Protection Policys-> Standard Sigs -> Click on the number to change

I hope this helps

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Leo Laohoo · ‎05-03-2009

In addition to George's post, try this:

Management > SNMP > Trap Controls

Go to the Client Tab for the Association and go the the AP Tab for the Radios.

Hope this helps.