cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
313
Views
0
Helpful
2
Replies

LWAP Rogue Detector AP - alerting

cchandler63
Level 1
Level 1

Has anyone figured out a way to get an AP set in Rogue Detector mode to stop alerting radio down/assoc/disassoc. The radio is down I understand but if you leave an AP in RD mode to monitor wired traffic you are going to get a flood of alerts...

Using v4.2.176. Thanks,

2 Replies 2

George Stefanick
VIP Alumni
VIP Alumni

You can change the sigs under

Security-> Wireless Protection Policys-> Standard Sigs -> Click on the number to change

I hope this helps

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Leo Laohoo
Hall of Fame
Hall of Fame

In addition to George's post, try this:

Management > SNMP > Trap Controls

Go to the Client Tab for the Association and go the the AP Tab for the Radios.

Hope this helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: