Cisco Router and Switch

Unanswered Question
May 2nd, 2009

Please help me find this Cisco Router and Switch with specs below:

SPECIFICATIONS for Router

Must have 2 10/100/1000 Ethernet fixed interfaces ports

On board encrption

Support up to 1500 VPN tunnels with the AIM-EPEII_PLUS Module

Antivirus defense support through Network Admission Control (NAC)

Intrusion Prevention as well as stateful CISCO IOS Firewall support and many more essential security features

Analog and digital voice call support

Dedicated Extension Voice Module slot

Optional voice mail support

Should have 3 internal slots for PVDM's to support voice transcoding

Optional support for Cisco CallManager Express for local call processing in stand alone business for up to 96 IP phones

Optional support for Survival Remote Site Telephony support for local processing in small enterprise branch offices for up to 96 IP phone

Should have 1000MB DRAM and 256MB flash

Should provide 4 slots, each slot can support HWIC, WIC, VIC or VWIC type modules

Must support multiple optional types of Ethernet and serial connections

Should support one Network-Module Slot

Must have Integrated hardware-Based Encryption

Must support DES, 3DES, AES 128, AES 192 and AES 256 VPN hardware acceleration or motherboard

Must support dynamic multipoint VPN

Must support Group Encrypted Transport VPN

Must support Network admission control

Must support access control list

Must support committed access rate.

Must support one or two onboard USB 1.1 ports

Must support the optional security modules (IPS,VPN, content engine network modules)

SPECIFICATIONS for switch

32 Giga bps forwarding bandwith

24 port 10/100

Forwarding rate 38.7Mpps for the 128 MB DRAM

32 MB Flash Memory

Configurable up to 12,000 MAC Addresses

Configurable up to 11,000 unicast routes

Configurable up to 1000 IGMP groups and multicast routes

Configurable maximum transmission unit (MTU) of up to 9000 bytes with a maximum Ethernet frame size of 9018 bytes (Jumbo frames) for bridging on Gigabit Ethernet ports and up to 1546 bytes for bridging of Multi protocol Label switching (MPLS) tagged frames on 10/100 ports

Should support power over Ethernet POE on all ports on all access switches

The 24 ports switches should have 2 SFP

It should support 802.1 x protocol

The switches should use internal SFP interconnect

It should support all layer three protocols and support ACL's equal path routing and advanced spanning tree feature for higher redundancy.

thanks in advance!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion