SNMP lightweight access point connected to Controller 4400

Unanswered Question
May 4th, 2009

I am trying to monitor via snmp the access point directly. I am trying to consolidate the SNMP MIB of the 1250 ap's connected to the 4400 controller Release 5.2.

Do anyone knows if it's possible to monitor the access point directly (not via the controller) with SNMP?

Thanks, Wim

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
cindy toy Wed, 05/06/2009 - 23:43

Hi Wim,

Thanks for posting. Since this is not a small business product, I suggest posting this question in the Cisco NetPro Community http://forums.cisco.com/eforum/servlet/NetProf for input from appropriate subject matter experts. NetPro is a peer and expert forum where you can get suggestions and information from networking professionals on a variety of solutions and technologies.

Let me know if you have any questions.

Best regards,

Cindy Toy

Cisco Small Business

Support Community Manager

princesegunloves Thu, 05/07/2009 - 07:43

Yes. you need to go to the GUI of the controller and enable access wireless via client . I think that should work.U need to put the ip address of the LAP u got from the controller in ur browser .

Cheers

Actions

This Discussion