05-04-2009 01:11 PM - edited 03-06-2019 05:31 AM
Hello, I need to do DHCP snooping on a 2950 with IOS 12.1(13)EA1. I follow the documented procedure but all I can get is
switch(config)#ip dhcp snoop
^
% Invalid input detected at '^' marker.
Am I doing something wrong, or must I upgrade? Does every 2950 work? Which is the IOS needed?
Thank you in advance
05-04-2009 01:24 PM
Available on 12.1(19)EA1 or later
HTH,
__
Edison.
05-11-2009 10:13 AM
Edison,
Thank you very much for your response, I was not aware of that document. However, I have given both c2950-i6q4l2-mz.121-19.EA1.bin and c2950-i6q4l2-mz.121-20.EA1.bin a try and I keep getting the same. Does the kind of switch prevent me from using the command? I am running the standard feature set:
cisco WS-C2950-24 (RC32300) processor (revision J0) with 20713K bytes of memory.
Processor board ID FHK0723W0B3
Last reset from system-reset
Running Standard Image
24 FastEthernet/IEEE 802.3 interface(s)
05-11-2009 10:36 AM
You need the Enhanced Image, please refer to the IOS release documentation for further info:
HTH,
__
Edison.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: