SRST - Translation Rules and Hunt Groups

Unanswered Question
May 5th, 2009
User Badges:


Hi,


I've copied and paated a template configuration below.


Here's some background:


The voice gateway receives the last 6 digits of the DDI range (005000-005249).


If a caller dials 0117 9005053 or 0117 9005092, the call should get routed to Hunt Group 3 which has a pilot number of 100.


If a caller dials 0117 9005100 the call should get routed to Hunt Group 5 which has a pilot number of 441179005100.

If the caller dials any other number (that does not match DDI of a registered phone) the call should get routed to Hunt Group 4 which has a pilot number of 101.


Will the template configuration achieve these goals?


voice translation-rule 1

rule 1 /005053/ /100/

rule 2 /005092/ /100/

rule 3 /005/ /441179005/

rule 4 /^0/ /101

!

voice translation-rule 2

rule 1 /^.*/ /9\0/

!

!

voice translation-profile IncomingCalls

translate calling 2

translate called 1

!

voice-port 0/0/0:15

translation-profile incoming IncomingCalls

cptone GB

!

!

!

ephone-hunt 3 sequential

pilot 100

list 11706, 11707, 11708

timeout 15

!

!

ephone-hunt 4 sequential

pilot 101

list 11710, 11711, 11712

timeout 15

!

!

ephone-hunt 5 sequential

pilot 441179005100

list 11701, 11702, 11703

timeout 15

!

!


telephony-service

srst mode auto-provision none

srst dn line-mode dual

em logout 0:0 0:0 0:0

max-ephones 100

max-dn 200

ip source-address 10.91.66.251 port 2000

timeouts interdigit 5

system message secondary WAN down - SRST

time-zone 23

time-format 24

date-format dd-mm-yy

max-conferences 12 gain -6

call-forward pattern .T

moh music-on-hold.au

multicast moh 239.1.1.1 port 16384 route 10.91.66.251 10.91.66.1 10.91.66.5

transfer-system full-consult

transfer-pattern .T

secondary-dialtone 9

create cnf-files version-stamp Jan 01 2002 00:00:00


Thanks




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chris Deren Tue, 05/05/2009 - 05:54
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,
  • Cisco Designated VIP,

    2017 IP Telephony, Contact Center, Unified Communications

Looks like it should be just fine.

Is your PRI H323 or MGCP controlled under normal condition (not SRST)? If it's H323 then appliying the translation to the voice-port will change it before it gets to CM as well, not sure if that is your intent. You may want to apply this to a voice dial-peer instead.


HTH,


Chris

gsidhu Tue, 05/05/2009 - 09:17
User Badges:

Hi Chris,


Thanks for your response. PRI is MGCP controlled.


Gurmakh

Actions

This Discussion