05-05-2009 07:15 AM - edited 03-15-2019 05:51 PM
Hi Pros,
I have a simple question, Can I enable huntstop in a dial-peer that already has trunkgroup enable? There is an example below.
dial-peer voice 1258 pots
huntstop
trunkgroup makeCall
destination-pattern 403450664[0-9]$
translate-outgoing called 258
direct-inward-dial
!
At the moment only the trunkgroup is present in the dial-peer. But I been experience some issues where can be tied up by the same number in coming number!!! Though the huntstop command might help.
Open to any ideas or suggestions.
Thanks in advance,
Crazy
05-11-2009 05:24 AM
Yes, you can enable huntstop in a dial-peer that already has trunkgroup enable.
05-11-2009 06:52 AM
Thank you so much for your response tstanik. My last question, is that going to help me? I was think to add the huntstop as a fix to avaid my getway to send a same call out of more than one port at a time.
Lately,my exprienced some issues where all the port are tied up by the same call at the same time!!!
Thanks,
Crazy
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: