Pix 501 to VPNC 3005 using Easy VPN

Unanswered Question
May 5th, 2009

I have a PIX 501 connecting to a VPN Concentrator 3005 using Easy VPN. It looks like everything SHOULD be set up correctly. However, when I enter "vpnclient enable" on the PIX I get the following response:

* Enroll and install certificate since key exchange

mechanism is cert based (RSA-Signature)

CONFIG CLASH: Configuration that would prevent successful PIX Easy VPN Remote

operation has been detected, and is listed above. Please resolve the

above configuration clashes and re-enable.

I have looked for anything related to RSA Signatures, etc on both sides and cannot find what I am looking for- how can I resolve this?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
tstanik Mon, 05/11/2009 - 13:52

You can see this if your PIX is configured as a VPNC doing certificate authentication. On the PIX CLI, do a clear conf all and then do a conf mem. You may try enabling the vpnc again.


This Discussion