05-05-2009 09:14 AM - edited 03-04-2019 04:38 AM
Hi, I have Router A and B having Frame-Relay connectivity. I have configured Virtual Templete 1 on PPP over FR on both side. I am able to ping both side. If I configure RIP or OSPF on that link, I am getting all advertised routes on the other side. But if I configure EIGRP, I am seeing that Neighbor is built, no there is no any router advertisement. Any idea why this is happening with Eigrp.
05-05-2009 11:49 AM
Send your configs please.
05-05-2009 11:51 AM
Rupesh,
Eigrp should be fine. It's a good idea to see what you configured on both sides. Are you trying to advertise loopback ip addresses? Please post a "sh
ip protocol" command on both sides.
Toshi
05-05-2009 07:42 PM
If I debug Eigrp pakcet Update, I am getting many logs as "Eigrp update - Ignored from ourselves"
int e0/0
ip addr 150.1.1.1 255.255.255.0
interface Serial0/0
encapsulation frame-relay
frame-relay interface-dlci 201 ppp Virtual-Template1
interface Virtual-Template1
ip address 54.1.7.6 255.255.255.0
router eigpr 10
no auto
network 54.1.7.6 0.0.0.0
network 150.1.1.1 0.0.0.0
05-05-2009 07:57 PM
Rupesh,
Please let me see "sh ip protocol" outputs on both sides.
Toshi
05-05-2009 08:04 PM
I would send u later as it is in office.
But I want to brief you, in IP Protocol, it is showing the Virtual-Access and other interface for publishing route. In Topology, I am not seeing any passive/active route for remote end. But Neighor is established.
05-05-2009 09:56 PM
Hi, You can find the same Problem on
http://www.groupstudy.com/archives/ccielab/200607/msg01621.html
05-06-2009 05:49 PM
No Champion in CIsco,,who can help me out.
05-06-2009 06:19 PM
Need "sh ip protocol" outputs on both sides.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: