05-05-2009 09:14 AM - edited 03-04-2019 04:38 AM
Hi, I have Router A and B having Frame-Relay connectivity. I have configured Virtual Templete 1 on PPP over FR on both side. I am able to ping both side. If I configure RIP or OSPF on that link, I am getting all advertised routes on the other side. But if I configure EIGRP, I am seeing that Neighbor is built, no there is no any router advertisement. Any idea why this is happening with Eigrp.
05-05-2009 11:49 AM
Send your configs please.
05-05-2009 11:51 AM
Rupesh,
Eigrp should be fine. It's a good idea to see what you configured on both sides. Are you trying to advertise loopback ip addresses? Please post a "sh
ip protocol" command on both sides.
Toshi
05-05-2009 07:42 PM
If I debug Eigrp pakcet Update, I am getting many logs as "Eigrp update - Ignored from ourselves"
int e0/0
ip addr 150.1.1.1 255.255.255.0
interface Serial0/0
encapsulation frame-relay
frame-relay interface-dlci 201 ppp Virtual-Template1
interface Virtual-Template1
ip address 54.1.7.6 255.255.255.0
router eigpr 10
no auto
network 54.1.7.6 0.0.0.0
network 150.1.1.1 0.0.0.0
05-05-2009 07:57 PM
Rupesh,
Please let me see "sh ip protocol" outputs on both sides.
Toshi
05-05-2009 08:04 PM
I would send u later as it is in office.
But I want to brief you, in IP Protocol, it is showing the Virtual-Access and other interface for publishing route. In Topology, I am not seeing any passive/active route for remote end. But Neighor is established.
05-05-2009 09:56 PM
Hi, You can find the same Problem on
http://www.groupstudy.com/archives/ccielab/200607/msg01621.html
05-06-2009 05:49 PM
No Champion in CIsco,,who can help me out.
05-06-2009 06:19 PM
Need "sh ip protocol" outputs on both sides.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide