IP SLA jitter output

Unanswered Question

Hi,


I've a setup with two 2800's on two datacenter and I want to see the jitter from one datacenter to the other. So I've configured an IP SLA and an responder but the output I get gives me only RTT and no jitter measurements. I've checked CCO and they say you get '0' when the devices are not timesynced. But I am sure they are in sync with each other.


Here is my config:


ip sla monitor 1

type jitter dest-ipaddr x.x.x.x dest-port 5000

request-data-size 64

tos 5

ip sla monitor schedule 1 life forever start-time now


on the other router:


ip sla monitor responder

ip sla monitor responder type udpEcho port 5000


Any ideas?


Gr,

Peter

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Here is the output:


R2#sh ip sla moni stat 1

Round trip time (RTT) Index 1

Latest RTT: 2 ms

Latest operation start time: 22:16:22.747 GMT+1 Tue May 5 2009

Latest operation return code: OK

RTT Values

Number Of RTT: 10

RTT Min/Avg/Max: 2/2/2 ms

Latency one-way time milliseconds

Number of one-way Samples: 0

Source to Destination one way Min/Avg/Max: 0/0/0 ms

Destination to Source one way Min/Avg/Max: 0/0/0 ms

Jitter time milliseconds

Number of SD Jitter Samples: 0

Number of DS Jitter Samples: 0

Source to Destination Jitter Min/Avg/Max: 0/0/0 ms

Destination to Source Jitter Min/Avg/Max: 0/0/0 ms

Packet Loss Values

Loss Source to Destination: 0 Loss Destination to Source: 0

Out Of Sequence: 0 Tail Drop: 10 Packet Late Arrival: 0

Voice Score Values

Calculated Planning Impairment Factor (ICPIF): 0

Mean Opinion Score (MOS): 0

Number of successes: 16

Number of failures: 0

Operation time to live: Forever


Actions

This Discussion