James Hawkins Sun, 05/10/2009 - 13:07

As far as I am aware it is impossible to set separate IP addresses for NIC1 and NIC2 in any LINUX based CUCM release.


You can set the NICs for active/standby but that is all.


Out of interest why do you need to put the second NIC in a different network?

metalium2007 Sun, 05/10/2009 - 13:24

Hello jamesha, thanks for your thoughts, i already realized that!


Well why? Good practice to have one service interface and one management interface.


Thanks!

Sascha Monteiro Sun, 05/10/2009 - 14:52

I am not sure if it's good practice for servers though..

If you would have 2 nic's with seperate subnets, you can easily introduce faults by i.e. configuring incorrect routes etc.


We use iLo however, which is on a seperate subnet, and with advanced license you can even connect to the CLI interface. (only when things turned to custard ;-) )

Actions

This Discussion