Collin Clark Wed, 05/06/2009 - 08:30
User Badges:
  • Purple, 4500 points or more

You need to "move" the show commands to another privilege level then assign the user to that level.


jtalbaugh Wed, 05/06/2009 - 09:29
User Badges:

For example:


Router(config)#privilege exec level 4 sh run


Router(config)#username cisco privilege 4 password cisco



Enable level is level 15.


You can create a new user with a level lower than that.


Then you will need to associate the show commands to the appropriate level.


Keep in mind that the sh run output might not show everything, because each command shown in the config would need to be authorized for the restricted user to see it.

Actions

This Discussion