05-06-2009 07:09 AM - edited 03-06-2019 05:34 AM
Hi all, is there a priv level I can give to my users to only allow them to do certain show commands ?
05-06-2009 08:30 AM
You need to "move" the show commands to another privilege level then assign the user to that level.
05-06-2009 09:29 AM
For example:
Router(config)#privilege exec level 4 sh run
Router(config)#username cisco privilege 4 password cisco
05-07-2009 01:28 AM
what is the enable level for then? can I not use this ?
05-07-2009 07:40 AM
Enable level is level 15.
You can create a new user with a level lower than that.
Then you will need to associate the show commands to the appropriate level.
Keep in mind that the sh run output might not show everything, because each command shown in the config would need to be authorized for the restricted user to see it.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide