sip-ua authentication to Telia in Sweden

Answered Question
May 6th, 2009

Have anyone configured a SIP Trunk to Telia on CME 7.1?

This is what Telia THINK the sip-ua shall look like.

Config:

sip-ua

authentication username 00000000 password xxxxxxxxxxx

no remote-party-id

retry invite 2

retry register 3

timers connect 100

registrar dns:telia.com expires 3600

sip-server dns:telia.com

host-registrar

Some how it will not register. When I use X-Lite client on my PC from CounterPath I get the SIP Trunk up and running and can do calls, same username and password so the SIP Trunk is working but not on Cisco 2811 with CME 7.1

Her is the debug:

May 6 10:18:29.269: //-1/xxxxxxxxxxxx/SIP/Info/ccsip_process_sipspi_queue_event

: ccsip_spi_get_msg_type returned: 3 for event 7

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPIIcpifUpdate: CallState: 2

Playout: 0 DiscTime:263596 ConnTime 0

May 6 10:18:29.273: //14/F0EE245B8025/SIP/State/sipSPIChangeState: 0x4A41D134 :

State change from (STATE_DISCONNECTING, SUBSTATE_NONE) to (STATE_DEAD, SUBSTAT

E_NONE)

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Call/sipSPICallInfo:

The Call Setup Information is:

Call Control Block (CCB) : 0x4A41D134

State of The Call : STATE_DEAD

TCP Sockets Used : NO

Calling Number : 055555555

Called Number : 004791300000

Source IP Address (Sig ): 200.200.200.100

Destn SIP Req Addr:Port : :5060

Destn SIP Resp Addr:Port : :5060

Destination Name : telia.com

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Call/sipSPICallInfo:

Disconnect Cause (CC) : 3

Disconnect Cause (SIP) : 200

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPIUdeleteccCallIdFromTable:

Removing call id E

May 6 10:18:29.273: //-1/xxxxxxxxxxxx/SIP/Info/sipSPIDeleteContextFromTable: Co

ntext for key=[6] removed.

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPIUdeleteCcbFromUACTable: **

**Deleting from UAC table.

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPIUdeleteCcbFromTable: Delet

ing from table. ccb=0x4A41D134 [email protected]

181

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPIFlushEventBufferQueue: The

re are 0 events on the internal queue that are going to be free'd

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/ccsip_qos_cleanup: Entry

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPI_ipip_free_codec_profile:

Codec Profiles Freed

May 6 10:18:29.273: //14/F0EE245B8025/SIP/Info/sipSPIUfreeOneCCB: Freeing ccb 4

A41D134

May 6 10:18:29.273: //-1/xxxxxxxxxxxx/SIP/Info/sipSPIGetContextFromTable: NO co

ntext for key[6]

I have this problem too.
0 votes
Correct Answer by chadlincoln about 7 years 7 months ago

Post the output for "show sip-ua reg stat"

If the telco is expecting you to register your main number, you'll have that under an ephone-dn. For example, if they want to see registered 555-555-5555, you'd put this:

ephone-dn

number 5555555555

Then run the "sh sip-ua reg stat" command again and you should at least see the number trying to register.

Please rate if this helped.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (1 ratings)
Loading.
Nicholas Matthews Wed, 05/06/2009 - 09:23

These debugs aren't helpful without their context. They describe the events of a sip message (and conversation) that aren't referenced.

-nick

Correct Answer
chadlincoln Wed, 05/06/2009 - 19:26

Post the output for "show sip-ua reg stat"

If the telco is expecting you to register your main number, you'll have that under an ephone-dn. For example, if they want to see registered 555-555-5555, you'd put this:

ephone-dn

number 5555555555

Then run the "sh sip-ua reg stat" command again and you should at least see the number trying to register.

Please rate if this helped.

Actions

This Discussion