Codes for show dot11 statistics client-traffic

Unanswered Question
May 6th, 2009
User Badges:

Does anyone know how to interpret the output from the show dot11 statistics client-traffic command??


Here's an example:


Dot11Radio0: -- Client Statistics

---Clients AID VLAN Status Age Tx Mode Enc Key Rate

000e.8e15.6da8 1 2 0000 1400000FE 20/20 0-0 1CB0 000 0-0 1EFF1FFF 40D

Rx Pkts KBytes Dup Dec Mic Mis Tx Pkts KBytes Retry RSSI SNR

000e.8e15.6da8 1259588 379373 575 0 0 0 1208830 668232 233312 37 54

Block Ack Pri, Rcv Wind Timeout SeqNum Held, Xmt Wind Timeout

000e.8e15.6da8 0 64 0 8F80 0 64 0 0 0 0

8021x auth in prog 0 allowed 0


Thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tstanik Tue, 05/12/2009 - 14:38
User Badges:
  • Bronze, 100 points or more

All of the information contained in the output of SHOW DOT11 STATISTICS CLIENT-TRAFFIC relates to layer 2 activities. This command shows the output Signal strength & signal quality.


Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode