05-06-2009 10:43 AM - edited 07-03-2021 05:33 PM
Does anyone know how to interpret the output from the show dot11 statistics client-traffic command??
Here's an example:
Dot11Radio0: -- Client Statistics
---Clients AID VLAN Status Age Tx Mode Enc Key Rate
000e.8e15.6da8 1 2 0000 1400000FE 20/20 0-0 1CB0 000 0-0 1EFF1FFF 40D
Rx Pkts KBytes Dup Dec Mic Mis Tx Pkts KBytes Retry RSSI SNR
000e.8e15.6da8 1259588 379373 575 0 0 0 1208830 668232 233312 37 54
Block Ack Pri, Rcv Wind Timeout SeqNum Held, Xmt Wind Timeout
000e.8e15.6da8 0 64 0 8F80 0 64 0 0 0 0
8021x auth in prog 0 allowed 0
Thanks in advance
05-12-2009 02:38 PM
All of the information contained in the output of SHOW DOT11 STATISTICS CLIENT-TRAFFIC relates to layer 2 activities. This command shows the output Signal strength & signal quality.
05-12-2009 02:44 PM
Right. But what do the codes mean?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide