NAT Problem

Unanswered Question
May 6th, 2009

Hello all, I am having an error with this lab and I am stuck. In the lab I finished the ACL part and it made me make an ACL that will not allow PC1 to receive traffic from the network that PC3 is on.

The last part of this lab is to configure nat.

It says Configure NAT to allow PC3 to ping PC1

I tried setting up a dynamic nat system on R3 (where PC3 is at) but I am not having any luck.

Here is the practice lab that I been doing.

What is wrong ? I am confused :(

The networks PC3 is on is /25 and PC1 is on network

Addressed used for R1 on Serial 0/0/0 is

Addresses used on R3s serial 0/0/0 interface is

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
John Blakley Thu, 05/07/2009 - 05:41

What kind of file is a .pkt file? Can you post a jpg of your topology?




This Discussion