Why did my 3560-E reboot?

Unanswered Question
May 7th, 2009
User Badges:

Is there a show command that would show why the system restarted. Specifically if it was restarted by a user from the cli. I thought a show version used to tell you this, but I don't see it now.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)

cisco WS-C3750-24P (PowerPC405) processor (revision J0) with 118784K/12280K bytes of memory.

Processor board ID CAT1030ZHB9

Last reset from power-on ----- This??

1 Virtual Ethernet interface

48 FastEthernet interfaces

4 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

stewartjs Thu, 05/07/2009 - 05:48
User Badges:

No, that appears if the power was unplugged or the system was restarted via CLI. I thought there used to be something more. Something like "system reload via system-restart command".


This Discussion