Duplicate outside circuit for redundancy on ASA

Answered Question
May 7th, 2009

We have an ASA running ver 8.0(4) and telco is proposing a scheme were two identically configured circuits would be handed to me. They would be active/passive in that both would be live but the second won't pass traffic unless the active circuit fails. How can I configure the ASA to support two connections that are Identically configured. Same VPNs, same address translations, same next hop, etc...

I have this problem too.
0 votes
Correct Answer by acomiskey about 7 years 6 months ago

What about a redundant pair?

ASA(config)# interface redundant 1

ASA(config-if)# member-interface gigabitethernet 0/0

ASA(config-if)# member-interface gigabitethernet 0/1

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
Correct Answer
acomiskey Thu, 05/07/2009 - 06:47

What about a redundant pair?

ASA(config)# interface redundant 1

ASA(config-if)# member-interface gigabitethernet 0/0

ASA(config-if)# member-interface gigabitethernet 0/1

Actions

This Discussion