can anyone explain to me line by line , Thanks

Unanswered Question
May 8th, 2009

Setting Parameters




show voice port 2/0:0

Type of voice port is cas

Operation State is DORMANT

Administrative State is UP

No Interface Down Failure

Description is not set

Noise Regeneration is enabled

Non Linear Processing is enabled

Non Linear Mute is disabled

Non Linear Threshold is -21 dB

Music On Hold Threshold is Set to -38 dBm

In Gain is Set to 0 dB

Out Attenuation is Set to 0 dB

Echo Cancellation is enabled

Echo Cancellation NLP mute is disabled

Echo Cancellation NLP threshold is -21 dB

Echo Cancel Coverage is set to 8 ms

Echo Cancel worst case ERL is set to 6 dB

Playout-delay Mode is set to adaptive

Playout-delay Nominal is set to 60 ms

Playout-delay Maximum is set to 250 ms

Playout-delay Minimum mode is set to default, value 40 ms

Playout-delay Fax is set to 300 ms

Connection Mode is normal

Connection Number is not set

Initial Time Out is set to 10 s

Interdigit Time Out is set to 10 s

Call Disconnect Time Out is set to 60 s

Ringing Time Out is set to 180 s

Wait Release Time Out is set to 30 s

Companding Type is u-law

Region Tone is set for US

Station name None, Station number None


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3 (1 ratings)
Loading.
Eldho E Kuriakose Fri, 05/08/2009 - 22:45

each one is self explanatery


which one u have doubt...


better to look i runniing config voice port conf

cisco steps Mon, 05/11/2009 - 10:08

Probalbly my question should read , what is the set up recommandation as we a have a voice delay to the work station , I also do have spaning tree configured w/ 4 switches , so I am trying to see where the delay is


Thanks again

Actions

This Discussion