05-08-2009 07:20 AM - edited 07-03-2021 05:34 PM
Hi,
we are using an 4404 with 5.2 and one new 1142 AP. Now i have an HP Notebook with the Intel 4965AGN running Proset 12.4.0.0. My Problem is that i won't get any higher Data Rate than 54 Mbit. We have activate 40Mhz Channel on 5 Ghz and activate N on that band - the other configuration is default on that a/n set.
Do you have any suggestions ??
Thanks Dennis
05-08-2009 07:46 AM
Dennis.
Have you checked the client and is N enabled on the client?
05-08-2009 08:09 AM
N rates are disabled if you set WEP or TKIP encryption. Make sure you're using either no encryption or AES.
05-11-2009 04:35 AM
Hi, N is enabled on the Client and Encryption is set to WPA2-AES.
Thanks Dennis
05-20-2009 05:28 AM
Dennis,
I had to set WMM to "allowed" on the WLAN in WCS to get the higher data rates in addition to using AES. On a side note, I have seen better data rates when disabling laptop wireless card power saving options with some models.
Randy
05-20-2009 06:14 AM
Have a look at this:
As already mentioned, be sure you have WPA2+AES or Open, and have WMM mode set to allowed.
Also, just curious, when you are connected to the SSID, does it show your connection speed at 54 or 300? Is the 54 that you are getting only throughput or is that what it shows you as connected as?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: