05-08-2009 07:38 AM - edited 03-06-2019 05:37 AM
Hi,
We have 2 3550 switch with same ios 12.1(22)EA4. I do not have any issue while applying route-map on secondary switch.
But when i try to apply the route-map on to the vlan, does not give any error and when i se the config of the vlan i do not see the route-map configuration on the int vlan 2.
ip access-list extended test
permit ip host 172.25.128.250 host 62.173.225.52
route-map expedia permit 1
match ip address test
set ip next-hop 192.168.128.18
int vlan 2
ip policy route-map test
any idea.
Thanks.
Satish
05-08-2009 07:41 AM
I think route-map name is expedia. Is that the problem or a typo?
Thanks.
05-08-2009 08:13 AM
sorry, the config was :
route-map test permit 1
match ip address test
set ip next-hop 192.168.128.18
int vlan 2
ip policy route-map test
Even this is not working.
regards,
05-08-2009 02:01 PM
Hi:
What do you mean it is not working?
How do you know? What test are you running? Can you post the complete outputs?
Thanks
05-08-2009 04:02 PM
ip policy route-map name should expedia, not test. test is the name of the acl you are matching against.
05-12-2009 09:10 AM
Satish
Are both switches using the same template to control switch resources? Can you post the output of show sdm prefer from both switches?
HTH
Rick
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: